Your new HANFLO™ Foot Valve comes ready for installation.
These Instructions are for those situations where you need to clean
out the valve in the event that grit or debris has reduced its
working efficiency.
Note: Before re-assembling make sure that all
components are fully cleaned.
- Turn
Foot Valve body upside down (as per picture).
- Seat
the diaphragm into the valve body.
- If
spring is removed, place it over the pin
and turn counter clockwise while still
pushing firmly to retain it on the spigot.
- Place
the cap onto the valve body.
- Screw
the cap fully onto the valve body and tighten
down, hand tight only.
The
information given on this page is for guidance
only. HANFLO™ accepts no responsibility
for the misuse or misapplication of this
information.
Click
Here to go to main Foot
Valve product page |
